토목 인프라 점검 17개 항목
Bridge Steel Coating (Paint) SSPC Inspection
이 체크리스트는 영어로 제공됩니다.
Quality and condition inspection of protective coatings on structural steel, covering surface prep, film thickness, adhesion, and defects per SSPC/AMPP standards.
SSPC/AMPP StandardsAASHTO/NSBA Steel Bridge CollaborationSSPC-PA 2
무료 PDF 또는 Word · 이메일을 입력하면 다운로드할 수 있습니다.
Project & Environment
- Structure ID / coating area designation *
- Date of inspection *
- Is the coating system a new application, maintenance overcoat, or condition survey? *
- Are ambient conditions (temp, humidity, dew point, surface temp) within specification? *
Surface Preparation
- Does abrasive blast cleanliness meet the specified SSPC grade (e.g., SP 10 near-white)? *
- Is the surface profile (anchor pattern) within the specified range? *
- Measured surface profile (mils)
- Are soluble salt/chloride levels below specified limits?
Coating Application & Thickness
- Does dry film thickness (DFT) of each coat meet SSPC-PA 2 acceptance? *
- Measured total DFT (mils)
- Is the coating free of runs, sags, overspray, dry spray, and pinholes? *
- Do holiday/pinhole detection results (where required) pass?
Adhesion & Existing Condition
- Does adhesion testing (pull-off / X-cut) meet the specified minimum?
- Is the existing coating free of active rust, blistering, cracking, or delamination? *
- Estimated percent of area with coating breakdown (%)
Actions
- Is spot repair, overcoat, or full recoat recommended? *
- Findings and recommended actions
Bridge Steel Coating (Paint) SSPC Inspection 체크리스트 전체 다운로드
인쇄하기 좋은 PDF 또는 편집 가능한 Word 문서로 무료로 받으세요.