社会インフラ点検 17項目
Lift/Pump Station SCADA Inspection
このチェックリストは英語版です。
Inspection of wastewater lift and pump stations including pumps, wet well, controls, and SCADA/telemetry systems for reliability, alarms, and safety compliance.
Ten States StandardsNFPA 820 (Wastewater Facilities)EPA Water/Wastewater SCADA Guidance
無料のPDFまたはWord・メールアドレスを入力してダウンロード。
Station Identification
- Station name / ID *
- Date of inspection *
- Station type (submersible, dry-pit, wet-pit, grinder)
Pumps & Wet Well
- Are all pumps operational and cycling normally with no unusual noise/vibration? *
- Are pump run-time and cycle counts balanced (alternation working)?
- Is the wet well free of excessive grease, debris, or grit accumulation? *
- Are check valves and isolation valves operating without leakage?
Controls & SCADA
- Do level sensors (float/transducer) accurately control pump start/stop setpoints? *
- Does the SCADA/telemetry system report status and transmit alarms to the operations center? *
- Were alarm functions tested (high wet-well, pump failure, power loss)? *
- Is the control panel/PLC free of faults and within firmware standards?
Power & Safety
- Is standby/backup power (generator or ATS) tested and functional? *
- Is confined-space entry signage and ventilation adequate per NFPA 820? *
- Is gas/hazardous atmosphere monitoring in place where required?
- Are electrical enclosures, grounding, and GFCI protection intact?
Findings
- Were any deficiencies or reliability concerns identified? *
- Notes and recommended actions
Lift/Pump Station SCADA Inspectionチェックリストの完全版をダウンロード
印刷しやすいPDF、または編集可能なWord文書で無料で入手できます。